Can I connect two batteries together?
We have had customers do it previously. The general idea is that it may give your board a better range and acceleration. However, this procedure would void your warranty as we generally don't promote this type of modification.
How do I assemble/adjust the belt/change PU sleeves for my NLS Belt?
Here is a video instruction for assembleing the Nls Belt:
Here is a video instruction for belt adjustment on Nls Belt:
Here is a video instruction for changing PU sleeves for hub motors:
How do I check the battery voltage?
While the battery is FULLY charged, check out the battery voltage following below technical support video:
PS: Multimeter is necessary for all electric skateboards, not only for MEEPO board. The Multimeter should be set as 200V.
How do I pair the remote with my board?
For M4 Remote:
1. Make sure the remote and the board have power.
2. Turn on the board and the remote.
3. Hold the POWER button on the board for about 5 seconds until the power light is blinking.
4. Hold the "FUNCTION(M4)" or "Reverse(other remotes)" and "POWER" button of remote at the same time f...
How to replace the motor for my City Rider 2?
If you are trying to repair or replace motors on your city rider 2, here is an instruction for you:
1.Unscrew the bolts on the outside lid
2.Unscrew the bolts on the other side and take the truck off
3.Take the thin metal ring off from the motor
4.Take the black metal lid off
5.Use the rubber ham...
My board is not turning off, what can I do?
Please do a test for us, so we could know if it is the problem of your ESC.
Here is an instruction:
1.Turn off the remote first.
2.Leave the board alone for about 15 minutes.
3.See if the board is able to turn off by itself. If the board doesn't turn off after 15 minutes, that means you would nee...
My NR remote doesn't work well, what can I do?
If you think there is something wrong with your NR remote, you could try resetting it.
Here is the instruction:
1. Stab the hole on the back of the NR remote with a wire or needle
2.At the same time, turn the remote on by holding the "power" button for 5 seconds.
3.Press the "Power" button again ...
One of my motors isn’t working well, what can I do?
If the motor is not working well, please open the ESC case to make sure all wires are connected well.
Then follow below technical support video to swap the motors cables.
https://youtu.be/XZOZiAc_SQ0 （For new ESC）
https://www.youtube.com/watch?v=RmlRqBm2gt8 (For old ESC）
Please share the moto...
Why my battery is not charging?
Here are some test questions we made for better diagnosing the problem:
Please view them carefully and respond to our Customer Service in order (photos and videos would also help)
1. Is the light of charger GREEN when you only plug the charger into the outlet not to the board?
2. Does the tiny ...